You think your pool might have a leak. Before you begin looking at Pool Leak Repair in Irving, TX, be sure that you are losing water to a leak, not to evaporation or splashing.
Place a weighted bucket on an entry step into the pool. Fill the bucket with water—only to the same level as the pool water around it. Mark the bucket with a Line At The Water Level. Turn off the pool pump and motor and leave the bucket for 24-48 hours. If the water level in the bucket is now higher than the water level in the pool, you definitely have a leak.
Repeat this test with the Pump And Motor turned on. If the water level in the pool is greater with the pump running (and the water under pressure) then the leak is likely in the pool’s plumbing.
You need to locate that Pool Leak in Irving, TX. There are several ways to try to locate the pool leak.
Walk around the perimeter of the pool. Walk the area between the pool and the Pool Motor Housing. The wet or soggy ground will give you the general location of the leak in Irving, TX.
Turn off the pump and filtration system. Leave the pool unused for a day or two. Note where the Water Seems To Stop Leaking. Check every day for a few days to determine where the water stays level.
If the water stays level at the skimmer, the pool leak in Irving, TX is likely in the Skimmer Or Filtration System. If the water stays level at the light fixture, then the leak is at the light. If the water level goes below the light fixture, your pool leak is probably in the pool wall, drain, or floor.
**This method should not be used on a pool with a vinyl liner.
With the pump motor and filter system turned off, drop a few drops of food coloring or liquid dye into the water. The dye will be pulled in the Direction Of The Leak in Irving, TX. This test might need to be repeated to accurately locate the pool leak.
A pool leak at the skimmer level may be as simple as a leak in the seal around the skimmer. Use the color test to determine exactly where the leak is. Pool leaks of this nature are easily Repaired With Pool putty.
However, a pool leak in the skimmer itself may require a Pool Skimmer Replacement. In Irving, TX, pool skimmer replacement is a job for the professionals because the leak may actually be part of the backend of the filtration system. A professional can detect and repair or replace the system parts that are causing the leak.
A pool leak at the light level may be from a break in the seal, or it could be from a crack in the fixture niche. Use the color test to determine the Location of The Pool Leak. If there is a crack in the fixture niche, call a Pool Repair Specialist in Irving, TX.
A pool leak in an inground pool, whether at the drain or the light or any other level, may require removing Part Of The Pool Decking. On the other hand, an inground pool leak may also require resurfacing in Irving, TX.
Often a swimming pool leak repair is resolved by a Pool Plumbing Repair in Irving, TX. If your pool leak appears to be in the pool pump system, contact a professional pool service and repair company.
We Find Solutions to Your Pool Problem
We wanted a resort in our backyard. Tropic Island did a great job of giving us just that. As a builder in Irving, they were professional and responsive. Building a pool has a lot of steps. They did a great job navigating all the way through and delivering a beautiful pool. I highly recommend them.
We needed a new pool heater. They came and installed a new heater, connected it to our automation, and hauled away the old heater. Great job. Thank you
Our pump stopped working. Kevin came out and repaired the electrical system. We are up and running again! Great work.
They installed our modern pool in our backyard. Great water features. Deck jets and bubblers. Wonderful. We recommend them as a Irving Pool Builder.
They built a lagoon oasis in our backyard. We have a beachfront entry - It’s amazing. The waterfall has a significant amount of water. Just what we wanted.
They came out and replaced our pool pump. Kevin did a great job.
We had a modern straight edge pool built by Tropic Island Pools. The design process was amazing. Many great ideas. The designer Dorinda was amazing. The pool ended up great. Thank you
We wanted a small pool in the backyard. The design was wonderful. We’re glad we picked Tropic Island Pools as our Irving pool builder. They did a great job.
Highly recommend Tropic Island Pools. They re-plastered our pool. All done in two days. Thank you.
They put in a new phone automation system. Now we control our pool from our phone! It works great. Thank you
We had a leak in our plumbing. Scheduled the technician to come out. Did a great job.
We called Tropic Island Pools. They came out and looked at our project. We went through the design process. The build process was good. All construction has its ups and downs, yet the project overall was great. We recommend Tropic Island Pools as your Irving Pool Builder.
We had Tropic Island remodel our Keller pool. They replaced coping, tile and plaster. The pool looks new after the changes. I recommend Tropic, they did good work.
We wanted a pool and spa in our Irving backyard. We went through the design process with Scott and Dorinda. They gave us many options. The pool ended up great. The entire family loves the pool. We recommend Tropic Island Pools.
Got everything fixed in a timely manner.